Request a Quote

DD2-A, protective covers

All covers are made-to-order for the application. To assure the best designed cover for your specific application, please check the applicable item, and give specific information where requested.

We have a database of over 10,000 covers. Please contact your Gortite® representative to locate your previous order(s) or to see if one fits your exact requirements.

Please fill out the form below. Fields marked with * are required.

For Quotation Only
Please supply a sketch / drawing / CAD file (DWG or DXF file format) / photo of your application.
Attach File

Application Information
*Plane of Movement
*Part Type to be Covered
(Please specify)

Environmental Conditions
*External Environment    
Please indicate percentage(s) for the following:
  Abrasive Particles –
(Dirt, dust, sand, grit, etc.)		 Dry  Grinding  Hot Chip
  Cutting Oils or Lubricants (Type)
  Chemicals (Type)
  Aluminum – Heavy Coolant   Water/Moisture
  Weld Splatter – Light   Hot Chip
  Other (please describe)
  Pressure: PSI =
  Vacuum: PSI =
*Temperature Range: Ambient:   Minimum:   Maximum:
  Maximum Travel Speed:
  Acceleration (Please indicate units of measurement:
  Movements/Day:   Axis:
*Internal Environment Clean Room    FDA
  Lubricants (Type)
  Hydraulic Fluids – Standard   Fire-Resistant
   

Cover Shape

Round  round Square/Rectangular square Other:
   
(Sketch required; DWG or DXF file preferred)

Cover Dimensions (Please specify in inches)

Cover Dimensions
Outside Diameter of Covered Part (Rod, screw, etc.):
Inside Diameter of Cover (Must be greater than the OD listed above; if left blank, Gortite will determine the proper clearance):
Maximum Allowable Cover Outside Diameter:
Extended Length (without ends):
Retracted Length (without ends):
Stroke / Travel Distance:

End Dimensions (Please specify in inches)

end dimensions
End 1:    
Standard Flange Flange I.D.:
  Flange O.D.:
Inside Flange Flange I.D.:
Collar Collar I.D.:
  Collar Width:
Flange-Type Collar Collar I.D.:
  Collar Width:
  Flange O.D.:
End 2 :    
Standard Flange Flange I.D.:
  Flange O.D.:
Inside Flange Flange I.D.:
Collar Collar I.D.:
  Collar Width:
Flange-Type Collar Collar I.D.:
  Collar Width:
  Flange O.D.:

Mounting Material & Accessories (check if required)

mounting material C208 Clamp (.5" I.D. Minimum)
Note: C208 Clamps are stocked in any size required. Clamp band width is 1/2".
C205 Flange-Type Back-Up Plate
Note: If flange-type back-up plates are required, please send sketch (DWG or DXF).
Mounting Holes (Specify):
Note: Plate orders without holes specified are shipped blank, without bolt holes.
Zippers
Additional Information:
Date
Quantity of Covers Needed
Date Required
Order Number
*Company Name
*Attention
*Mailing Address
*City
*State
*Zip Code
*Telephone Number
*Fax Number
*E-mail
Submitter's E-mail

An email with your request will be sent to you for your records.